Exclusief btw. Btw en verzendkosten berekend bij het afrekenen
12V jump starter · Three-speed air duster
KP700 combines 7,200mAh / 26.64Wh stored energy, USB device charging and an emergency light in one compact kit.
Multi-pack quantity
Btw en verzendkosten berekend bij het afrekenen
KP700 FEATURES
Each visual keeps the product and its useful in-image information intact. The text below each section adds the confirmed specification, operating context and safe-use guidance in a consistent SuntNeew reading style.
Four tools, one kit
KP700 combines a 12V jump starter, high-speed air duster, USB device charging and 2W emergency light. The product visual stays focused on the device; the supporting details below explain exactly what each function does.
Core specifications
KP700 is specified at 7,200mAh / 26.64Wh, 1,000A peak, 500A starting current and up to 105,000 RPM of air-duster speed. Use the full Specifications panel for temperature, ports and physical dimensions.
12V starting support
For compatible 12V vehicle batteries, KP700 is documented for engines up to 6.0L Gas or 4.0L Diesel, with 1,000A peak and 500A starting current. A full charge is rated for up to 25 starts; actual results vary with vehicle, battery health and temperature.
Three-speed air duster
The brushless fan has three documented speed levels: 30,000 RPM for up to 18 minutes, 70,000 RPM for up to 8 minutes and 100,000 RPM for up to 4.5 minutes. Maximum specification: 105,000 RPM / 360W / 550g wind pressure.
Outdoor cleanup
Use the air-duster function for light, dry debris around the vehicle and outdoor gear. Keep the jump starter, clamps and ports dry; this product is not presented as waterproof or IP rated.
Detail cleaning
The included air nozzle helps direct airflow for car vents, window tracks, seats and dry dusty surfaces. Start at a lower setting and avoid blowing debris toward eyes, moving parts or electronics.
Controls and ports
KP700 has a Type-C charging input, USB-A device output, EC5 jump-start port, fan control, lighting control and power key. The below specification table gives the supported 5V/2A input and output limits.
Intelligent clamp protection
The EC5 smart clamp uses a 10AWG cable and status/buzzer guidance. Its documented protection logic includes reverse polarity, short circuit, overcharge, over-discharge, over-current, overheating, high/low input voltage and timeout conditions.
Four-step starting
Make sure KP700 is at least 50% charged. Insert the clamp plug, connect red to positive and black to negative, wait for the green indication and start. Remove the clamp within 30 seconds after the vehicle starts.
Device charging
USB-A output supports everyday emergency charging at 5V/2A. Recharge KP700 through the Type-C port at 5V/2A in about four hours. Use the supplied USB-A to Type-C cable or an equivalent compatible cable.
Product details
Specifications are drawn from the KP700 English manual and approved product documentation. Follow the manual’s operating sequence and safety limits before every use.
What is included
Reference material
WHAT THE DOCUMENTS COVER
Four document categories help explain product safety, electromagnetic compatibility, battery transport and handling information.
KP700 SUPPORT
KP700 is for compatible 12V vehicle batteries, with a documented reference of up to 6.0L gasoline or 4.0L diesel engines. Do not attempt to jump-start a higher-rated engine or a battery with a different voltage.
The up-to-25-starts reference is based on the product documentation for a typical 1.5L passenger vehicle under a full charge. Results vary with engine size, battery condition, temperature and vehicle condition.
Charge the unit to at least 50%, insert the clamp plug, connect red to the positive terminal and black to the negative terminal, wait for the green indication, then start the vehicle. Remove the clamps within 30 seconds after the vehicle starts.
The documented three levels are 30,000 RPM for up to 18 minutes, 70,000 RPM for up to 8 minutes and 100,000 RPM for up to 4.5 minutes. The maximum fan speed specification is 105,000 RPM (±10%).
Yes. The USB-A output supports emergency device charging at 5V/2A. Recharge KP700 through its Type-C input at 5V/2A; typical recharge time is about four hours.
The 2W LED has Steady, Flashing and SOS modes. Turn the unit on, then press the lighting key to move through the modes.
No. Keep the unit, clamps and ports dry. The product is not marketed as waterproof or IP rated; do not rinse, submerge or use it when wet.
